1. Open DMSS, select "+" top right.
2. Scan QR code on Alarm Hub.
3. When prompted, change Dip switch from STA to AP (ensure blue LED on hub is blinking)
4. Configure Username and password to initialize.
5. Select the AP wifi network to connect to.
6. Chnage Dip switch back to STA.
7. Wait for app to connect to router then add device name for Hub.
8. Enable DST
Add device/Peripheral
1. Select "+" under Peripheral section on DMSS.
2. Scan QR code on back of device.
3. Give device name and set area.
4. Flip switch on device from off to on, indicator nlinks green and then adds successfully.
Add Card
(requires keyboard to be added first)
1. Select "+" under Peripheral section on DMSS, then select Add Card.
2. Swipe over keyboard to wake (buttons will illuminate)
3. Hold card to bottom of keyboard, wait for green tick on DMSS.
Add IPC
(NOTE: IPC needs to be Dahua and must be already initialized via PoE switch on same LAN as Hub)
1. Select "+" under Peripheral section on DMSS, then select Add IPC.
2. Find IPC through online search/IP address.
3. Give device a name and enter device password.
Delete Device
1. On the device list screen, press three dots at top right of each device
2. Press device details.
3. Scroll down, press Delete
(NOTE: Even when deleting Hub from app, the devices are still paried with hub and can still be armed/disarmed from keypad.
To delete hub and unpair all devices, factory default with pin using reset button)